Every restoration project starts with a surface wear inspection. The builder checks crack depth and pattern, identifies low spots where water pools, and assesses whether the existing base is stable enough for targeted repair or whether a section needs to be rebuilt. Houston’s expansive clay soils contribute to crack formation and surface movement, so base stability is confirmed before any patch compound or sealer is applied.
Crack filling uses a flexible compound matched to the crack width, followed by a surface sealer to prevent moisture intrusion. Low spots are leveled with patch compound and feathered to the surrounding surface so the playing area is consistent underfoot. Drainage correction is addressed at this stage if standing water is a documented problem, recoating without fixing the drainage slope brings the water back.
Acrylic coating is applied once repairs are cured and the surface is clean and dry. Houston’s UV intensity and summer heat accelerate coating breakdown on neglected surfaces, so the builder applies the correct number of coats for the surface condition rather than a single pass. Regulation line striping is the final step, applied over the cured coating for maximum adhesion and visibility.
Why Choose Us
Why Houston Court Hub for resurfacing & maintenance?
Process and accountability built into every job, from first call to final walkthrough.
Inspection Before Any Scope Is Written
An on-site evaluation of the surface, cracks, and drainage happens before a single line item is committed to paper.
Itemised Written Estimate
Every cost, crack filling, patching, recoating, line striping, appears as a separate line item, nothing implied.
Signed-Off Final Walkthrough
The job is not closed until a walkthrough confirms the surface, drainage, and lines meet the agreed scope.
Houston-Area Coverage
Site assessments serve Houston, The Woodlands, Katy, Sugar Land, Cypress, Fulshear, and surrounding areas.
All Court Settings Handled
Backyard courts, HOA facilities, school courts, and commercial properties are all within the service scope.
Does a cracked court always need full resurfacing?
No, the deciding factor is crack width, depth, and how many there are. Hairline cracks and isolated surface fractures can usually be filled and sealed without touching the rest of the court. Wide, structural cracks or a pattern of alligator cracking across large areas typically means the base has moved, and patching alone will not hold.
Can a repair or patch be enough, or do I need the whole surface redone?
A patch is enough when damage is limited to a small, defined area with a stable base underneath. If the coating is peeling across most of the court, cracks are widespread, or the surface has lost its texture uniformly, resurfacing the whole court gives a better long-term result than patching dozens of spots individually.
What happens if I wait and the cracks or peeling get worse?
Water gets into the cracks, expands in Houston’s heat cycles, and widens them further. What starts as a patchable crack can undermine the base layer within one or two seasons, turning a straightforward repair into a full base rebuild. Waiting also creates a trip hazard and increases injury risk for players.
Can maintenance help if my court is slick or holds water?
Yes, in most cases. A slick surface usually means the acrylic texture coat has worn smooth and needs a fresh application. Standing water points to low spots or a clogged perimeter drain. Resurfacing can correct minor drainage issues, though significant base grading problems need base repair before a new coat goes down.
Why is my court cracking, peeling, or wearing out so fast?
The most common causes are a base that was not compacted properly, poor drainage that lets moisture work under the surface, and Houston’s heat expanding and contracting the slab repeatedly. Low-grade coating applied too thin also peels within a few years. An on-site evaluation can identify which factor is driving the damage on your court.
Will resurfacing fix low spots or drainage problems, or is that a different repair?
Resurfacing can level minor low spots with a skim coat, but it cannot correct a base that has settled or shifted significantly. Drainage problems caused by the base slope need base repair first. Every job starts with an on-site evaluation that checks drainage before any coating work is scoped.
What all is included in court resurfacing and maintenance?
The scope typically covers crack filling, surface cleaning and prep, one or more acrylic coating layers, texture coat for traction, and fresh line marking. The written estimate itemises each step, base preparation, surfacing, and line marking, so you know exactly what is included before work starts.
Do you handle cracks, patching, resurfacing, and line marking, or just part of it?
The full scope is handled, crack repair, patching, resurfacing, and line marking are all part of the service. The itemised written estimate spells out which elements apply to your court so nothing is left to a separate contractor.
Share the location and the court’s condition, and we’ll arrange a surface inspection, check drainage, and put the full scope in writing before any work is scheduled.